Help
"Error Code" on the Display
If the Remote Control displays the error screen shown below, try to make a note of the numbers (the error code) on the top line. Then
P
press
, move the Remote Control closer, wait a few seconds, and try the action again.
Since most of the error codes you might encounter are related to communication, always try to resolve the problem by moving the
Remote Control closer to the Stimulator. If this does not work, please contact our Customer Service Department.
P
P
Note: The Remote Control will go to the Level screen when
is pressed, or to an idle mode if
is not pressed within one minute.
Patient Trial Handbook
90868464-08 REV A
31 of 159