3
Setting up
3.1
Safety information
NOTE: Before setting up, it is essential that you read the Safety Information at the beginning of
this operating manual.
3.2
Check contents of pack
The following items are supplied:
one base station
one handset
one telephone connecting cable
one belt clip
3.3
Connecting the base station
Position the telephone near to your telephone connection socket and to a mains socket.
1.
Insert the plug of the power supply into the socket on the underside of the base station and
plug the power supply into a properly installed 230 V mains socket. The plug-in power
supply for the base station must always be connected. For safety reasons, use only the
plug-in mains power supply provided.
2.
Connect the telephone cable supplied to the telephone socket and the telephone jack on
the underside of the base station. Use only the new telephone cable provided.
3.4
Fitting standard batteries
To fit the standard rechargeable batteries supplied into the handset, press on the
upper edge of the battery compartment and slide it downwards. Now insert the
batteries taking care to ensure that the polarity is correct. Close the battery
compartment cover.
Important note: Place the handset in the base station with the display to the front for
at least 16 hours. The telephone may malfunction if the batteries are not properly
charged. The charging light
3.5
Charging the standard batteries
The rechargeable batteries for your telephone have a stand-by time of max. 100 hours at room
temperature and a maximum talk time of up to 8 hours. The current battery capacity is shown in
the display.
To charge the batteries, place the handset in the base station with the display to the front.
- Setting up -
one power supply with cable
three standard batteries
one instruction manual
on the base station will come on.
85