WMF 10 Bedienungsanleitung Seite 96

Caring for the coffee pad machine.
>
Take out the water filter from the water tank and place the steam nozzle in place of the water filter.
>
Put on the suction cap firmly back on again.
>
Ensure that the arrow marking on the suction cap points towards the floating capsule. (see the section
"Assembling the suction cap" on page 8).
>
Pour 125 ml durgol® swiss espresso® descaler into the provided collecting vessel.
>
Then fill it with tap water up to a total volume of at least 1 to 1.2 litres.
>
Then pour the descaler solution into the empty water tank and insert the latter into the appliance.
>
Then place the empty collecting vessel below the spouts of the beverage dispenser.
>
Ensure that the empty pad cassette is pushed in and rotate the locking knob to position
>
Switch on the appliance with the On/Off/C-button.
Descaling
>
Immediately after switching on, keep the descaling button pressed down (3 to 4 seconds) until the
pump starts.
With the start of the descaling program, the descaling button glows continuously. After about 30
minutes, the first section of the descaling program is over. The illuminated cross flashes red.
>
Rinse the water tank and then fill it with 1 litre of tap water.
Rinsing
>
Replace the water tank in the appliance.
The cleaning button flashes.
>
Replace the empty collecting vessel below the spouts.
>
Press the cleaning button.
Rinsing starts.
>
As soon as the illuminated cross flashes red again, rinse it again. Repeat the specified steps.
37
.