Installation; Attaching The Mobile Warning Unit - Linde Safety Guard Originalbetriebsanleitung

4
Operation

Installation

Installation

Attaching the mobile warning unit

 Switch on the mobile warning unit. To do
this, push and hold the push button (2) for
one second.
The mobile warning unit starts. A signal tone
is heard, the LEDs of the warning zones light
up and the device vibrates briefly.
 Check the charge state of the battery.
The LED must flash green. If the LED flashes
red, the mobile warning unit needs charging.
 Attach the mobile warning unit to the outside
of your workwear using the clip (1).
DANGER
Risk of accident and personal injury
Incorrect attachment can lead to incorrect radio
communications!
 Wear the mobile warning unit high on your body.
 Wear the mobile warning unit such that it is
unobstructed.
28
1
Operating Instructions – 3008011701 EN – 12/2018
2