Important note in the case of repairs:
When returning the device for repair, for safety rea-
sons, ensure that it is free of oil and fuel when it is
sent to the service centre!
Periodic maintenance and care instructions
For a long service life as well as to prevent damage
and to ensure the full function of the safety devices,
the maintenance tasks described below must be car-
ried out at regular intervals. Guarantee claims will
only be accepted if these tasks have been carried
out properly and at regular intervals. There is a risk
of accidents if disregarded!
General
Complete chainsaw
Saw chain
Chain brake
Guide bar
Before start up
Saw chain
Guide bar
Chain lubrication
Chain brake
STOP switch, safety shut-off
button, throttle lever
Fuel tank and oil tank caps
Daily
Air filter
Guide bar
Guide bar mount
Idle speed
Weekly
Fan housing
Cylinder area
Spark plug
Silencer
Protective sleeve for chain
trap
Screws and nuts
Quarterly
Suction head
Fuel tank, chain oil tank
Storage
Complete chainsaw
Saw chain and guide bar
Fuel tank, chain oil tank
Carburettor
www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
Users of chainsaws are permitted to carry out on-
ly those maintenance and care tasks described in
these operating instructions.
All other work may only be performed by a special-
ist workshop.
Clean the exterior and check for damage
In the event of damage, have a professional repair carried
out immediately
Sharpen regularly, replace in good time
Have it checked in a specialist workshop at regular intervals
Turn so that the running surfaces wear evenly. Replace in
good time
Check for damage and sharpness
Check chain tension
Check for damage
Functional check
Functional check
Functional check
Check sealing
Clean
Check for damage, clean oil inlet hole
Clean, in particular the oil guide groove
Check (saw chain shall not run)
Clean in order to ensure trouble-free routing of cooling air
Clean
Check, replace if necessary
Check for clogging
Check for damage, replace if necessary
Check condition and firm seating
Replace
Clean
Clean the exterior and check for damage
In the event of damage, have a professional repair carried
out immediately
Remove, clean and oil lightly
Clean guide bar guide groove
Empty and clean
Run until empty
GB | 51