Installation - SMART MX02L Bedienungsanleitung

Receiver ZF channel
Receiver 5
Receiver 6
Receiver 7
Receiver 8
Enter the frequencies of your receiving system in the last
column of the table so that you can always have an overview of
all relevant data at a glance.
The rule of thumb is: maximum frequency  shortest cable
path.

14.3 Installation

 Switch on receiver.
 Press on the remote control
 Select "Installation" using the
confirm.
 Enter the password (on delivery 0000 is preset). The Installation menu is
displayed.
 Select the menu item "Antenna Setup" and confirm.
 Select the menu item "LNB Freq." and select "Unicable (9750-10600)" there
 Select the menu item "IF Channel" and set a ZF channel there
(start with channel "1"; assign one of the ZF channels in ascending order to
every connected receiver).
 Select the menu item "Center Freq" and set the frequency belonging to the
ZF channel (see assignment table).
 If the set frequency is correct, the level indicators "Signal strength" and
"Signal quality" will indicate the value immediately.
 Press the key. The settings are saved. You are in the "Installation menu"
again
smart MX02L
Sample frequency [MHz]
5
6
7
8
Operation in a Unicable System
Frequency [MHz]
1748
1864
1980
2096
and keys and press to
61