Cleaning - Tektronix P5210 Anleitung

The lower the impedance of the probe relative to that of the source,
the more the probe loads the circuit under test. For a graph of
frequency versus input impedance, refer to Figure 5 on page 27. As
the graph shows, the probe has virtually no loading effect on sources
with relatively low impedance and low frequency.

Cleaning

Remove dirt with a soft cloth dampened in a mild detergent and
water solution or isopropyl alcohol and water.
CAUTION. To avoid damaging the probe, use only a mild detergent
and water solution or isopropyl alcohol. Do not use any other
solvents or abrasive cleaners. Do not immerse the probe.
P5210 Instructions
Operating Basics
17