Brother P-touch 9200DX Kurzanleitung Seite 9

When connecting to the USB port:
You must install the software first before connecting to the USB interface or turning on the power. Please follow the
installation procedures on pages 6 through 12 before connecting up or turning the power on. The Brother P-touch
installation software will instruct you when to do this.
1 Connect one end of the enclosed USB interface cable to the USB connector (
end of the cable to the USB port of the computer.
Do not connect the PT-9200DX to the computer using both the serial and the USB interface cables, otherwise
the PT-9200DX may be damaged.
When making a USB connection through a hub, a proper connection may not be possible due to the type of
hub used. If printing is not possible with a hub connection, try connecting the PT-9200DX directly to the
computer using the USB interface cable.
2 Insert the plug on one end of the power supply cord into the power supply jack on the PT-9200DX.
3 Insert the plug on the other end of the power supply cord into an AC outlet equipped with a grounding terminal.
Some locations may require the use of an adapter provided with a grounding wire. Connect this wire to the ground
terminal.
USB
) of the PT-9200DX and the other
5