Before Initial Start-Up; Electrical Connection; Eg- Declaration Of Conformity - REDWELL Middlewave R400 Bedienungsanleitung

Redwell Redwell

BEfoRE initiaL staRt-uP

Read the safety instructions and the manual before use! Check the infrared heating element for visible damage and whether the
mains voltage is in accordance with the voltage information on the type plate (verso). if you notice damages on the element, do not
use it - contact your specialist dealer.
we recommend that you not throw away the original package of the device. store the original package for possible transport.
staRt-uP
install the infrared heating element with the delivered assembly kit and connect with the mains cable!
assEmBLY
For the assembly please use the included drilling template with instruction. after having suspended the infrared heating element on
the wall or ceiling please firmly tighten all screws with the enclosed ring spanner for safety.
For ceiling mounting please use the fixture systems which are additionally available - you will find the mounting instructions in the
carton. no assembly for all mobile heating elements (standing models, pillars etc.) – can be plugged into a socket and are ready for
operation.

ELEctRicaL connEction

The infrared heating element is provided with a mains plug. after having finished the assembly, connect to a 230 Volt, 50 Hz socket.
Room temperature controller can be included in the system by adapter plugs (socket thermostat) or in case of a fixed connection,
consult an installation specialist to install a control - taking into account the appropriate standards and norms of the country con-
cerned.
cLEaning anD caRE
before cleaning, always disconnect the main power plug. to clean you should use a smooth and damp cloth and a little dish deter-
gent. never clean the infrared heating element and the power supply cables under running water, nor submerse in water. do not use
harsh, abrasive or easily inflammable detergents.

Eg- DEcLaRation of confoRmitY

The Redwell Manufaktur gmbH declares that this device is in conformity with the eMC regulation eMV 2004/108/eg and
with the low-Voltage directive 2006/95/eg.
DisPosaL
The infrared heating element has to be disposed separately from general household waste at government places provided for
this purpose. You can obtain detailed information for disposal at the specialist dealer where the product was purchased
designates that failure to comply with these can endanger your health and/or the function of your infrared heating element.
designates, that the infrared heating element is conform to the european directive 2002/96/eg.
The appropriate disposal and collection of scrap equipment serve to prevent potential environmental and health damages.
They are a requirement for the re-use and recycling of used electric and electronic devices.
designates further information and tips
designates that the infrared heating element must not be covered.
8 - gb