Mitsubishi Electric CITY MULTI PAC-PH01EHY-E Installationshandbuch Seite 12

8
L/XL-module
[Fig. 8.1.1.1]
Left side
[Fig. 8.1.1.2]
A
<A>
12
B
A
A
<A>
<A> Pull up the panel heater wirings so that the wirings run along the left rear pillar.
<B> Thread the panel heater wirings through the long hole on the left rear pillar.
<C> Attach the rubber sheet to the left frame so that the heat exchanger fin will be
covered. (Using the wiring access hole and the tab on the frame as a reference
position)
<D> Pull the wiring through the hole on the left frame and bring it into the inner side of
the heat exchanger.
A Panel heater wiring
B Left rear pillar
C Left frame
D Plate rubber
E Wire seal
* If the frame is not painted, place the supplied wire seal
around the hole.
C
8.1.1
<B>
<A> Screw down the metal sheet wiring cover at three points.
A Cover wiring 1
B Cover wiring 2
C Cover wiring 4
B
*C
A
<C, D>
Hole
Tab
E
D