Learn Function; Notes On Learn Function - Medion MD 82467 Bedienungsanleitung

Learn function

You can manually save the functions of an original remote control to your
universal remote control. Commands are saved to the mode key on which the
device of the original remote control was programmed.
The universal remote control can "learn" up to 150 commands.

Notes on learn function

•
Use new batteries for both remote controls.
•
If you start programming from the start – especially after the first operation
– delete all saved commands first of all (see "Deleting commands for all
mode keys" on page 26).
•
Only one original remote control can be programmed on each mode key.
•
If you would like to program an original remote control to a mode key, first
delete the commands on this mode key (see Deleting commands for only
one mode key on page 26).
•
LEARN ERROR
The
delete saved commands.
•
Programming each key can take approx. 3 seconds. Do not release the key
to be learned before the
•
The following keys cannot be assigned to functions: SETUP, MACRO and
all mode keys.
•
Some original remote controls (for DVD, video recorder, SAT) can
themselves be programmed with the device codes of some TV brands to
carry out basic TV set functions (volume, mute, channel search).
Do not attempt to transfer the functions of an original remote control that
has been programmed with the code of a different TV set to your universal
remote control. This could cause programming errors.
•
First try to program two or three commands and then test them.
•
Before programming in your commands, first delete all existing commands
(see "Deleting commands for all mode keys" on page 26).
Do not execute the learn function under a low-energy lamp. Such lamps
(e.g. fluorescent lamps) can contain infrared light components that could
influence the learn function.
24
message is displayed if the memory is full. If this happens,
SUCCESS
or
LEARN ERROR
message appears.