Deleting A Transmitter/Channel; Deleting All Transmitters; Technical Data; Replacing The Battery - Griesser BiLine UniTec series Original Bedienungsanleitung

Deleting a transmitter / Technical data

Deleting a transmitter/channel

1. Press the STOP button and also the programming button P
(below the cover).
2. Hold down this button combination for approx. 6 seconds until
the status LED briefly lights up orange and then red.

Deleting all transmitters

1. Press the STOP button and also:
• Programming button P (below the cover)
• UP button
• DOWN button
2. Hold down this button combination for approx. 6 seconds until
the status LED briefly lights up orange and then red.

Technical data

Operating voltage
Battery CR 2032
Protection class
Permitted ambient temperature
Radio frequency
22 | EN
3 V DC
IP20
0 °C to +50 °C
868 MHz band or
915 MHz band
Changing the batteries / cleaning/disposal

Replacing the battery

NOTE!
• Replace batteries only with the identical type
(1 x CR 2032).
• Dispose of used batteries properly (collection
point).
Replacing the battery
1. Slide the wall transmitter upwards
from the retaining spring.
2. Remove the battery.
3. Insert a new battery
correctly.

Cleaning

Clean the device with a damp cloth only.
Do not use cleaning agents, these can attack the plastic.

Disposal

Please observe the current national regulations. Dispose of
according to the condition and existing regulations.
e.g. as:
• Electronic waste (PCB)
• Plastic (housing parts)
• Batteries
CR
2032
EN | 23