Operation - Sirona C1+ Gebrauchsanweisung

19 Surgery with saline solution (NaCl)

19.3 Operation

Am.
Test
19.3
Operation
NaCl
#
76
#
3
0
C
E1
1000
NaCl
The basic setting dialog 1 appears.
One or two receptacles for surgery can be preset with
the two keys at the bottom right.
All instruments must be deposited in their receptacles!
If only one receptacle should be equipped with NaCl
cooling, then "0" must be set on one key and the number
of the corresponding receptacle (e.g. 3) on the other key.
With a second NaCl pump, the number of the corre-
sponding receptacle must be set on the lower key.
Receptacles 2–6 and 0 (without NaCl) can be selected.
The basic setting dialog 1 and the Service dialog disap-
pear automatically after some time.
However, you can also manually exit either dialog by
pressing the left arrow key.
When an electric motor with surgery (NaCl) presetting
is removed, the electric motor instrument dialog
appears.
With the key at the top left, the coolant can be switched
ON (bold frame) or OFF
.
Spray cooling or NaCl cooling can be preselected with
the fifth key from above on the left.
The symbol of the preselected medium then appears on
the coolant ON / OFF key.
It is not possible to preselect air.
If the coolant ON / OFF key with NaCl symbol is actuated
longer, then the setting dialog for the intensity adjust-
ment of the saline solution pump appears.
The intensity can be adjusted in 15 steps.
If two receptacles are used, this adjustment applies for
both receptacles.
Sirona Dental Systems GmbH
59 06 446 D 3386
D 3386.201.01.08.02