Sirona C1+ Gebrauchsanweisung Seite 119

Sirona Dental Systems GmbH
Start
Stop
C
Start
San
.
59 06 446 D 3386
D 3386.201.01.08.02
San.
C
S
0m
30s
C
60
8 Key functions in the assistant dialog
Timer Start / Stop
Actuate the Start key. The time set runs down. At the
same time, Stop appears. The progress indicator fills
up.
An acoustic signal indicates when the time has elapsed.
The timing can be stopped by pressing the Stop key.
Switch to the sanitation program
(see Maintenance Instructions)
Freely selectable function
e.g. call key (connected by your service engineer)
The function can be preselected as key or switch in the
basic setting dialog 1 (see page page 54)
or
SIVISION control
(only as key)
The desired key function can be preselected in the basic
setting dialog 1 (see page page 54).
Function of keys, right row:
Cuspidor flushing ON / OFF.
After the key is actuated, the
amalgam rotor starts running (symbol flashes).
The flushing water starts to flow after a short delay (sym-
bol appears with a bold frame).
Programming the flushing time:
Press the cuspidor flushing key until the setting dialog
appears.
In this dialog the flushing time can be changed in 8 steps
ranging from 20 to 300 seconds (shown in the center of
the display) with the – / + keys.
The cuspidor flushing function can also be activated by
pressing the S key (see page page 34).
Switch to the
Chair program dialog(see page page 19).
23