Mitsubishi Electric PAC-YT52CRA Installationsanleitung Seite 11

8 Connect the connector to the top case.
Connect the connector on the bottom case to the socket on the top case.
Connect the
connector.
Important
To prevent malfunctions, do not remove the
protective sheet or the circuit board from the
top case.
9 Insert the wires into the clamp.
Important
Hold the wires in place with the clamp to
prevent undue force from being applied to
the terminal block and causing cable
breakage.
0 Install the top case on the bottom case.
Two mounting tabs are at the top of the top case.
Hook those two tabs onto the bottom case, and click the top case into place. Check that the case is
securely installed and not lifted.
Important
When attaching the top casing to the bottom
casing, push it until it they click into place.
If they are not properly locked into place,
they may fall, causing personal injury,
controller damage, or malfunctions.
ON
1 2 3 4
OFF
– 11 –
To prevent cable breakage and
malfunctions, do not hang the top controller
casing hang by the cable as shown in the
figure above.
Insert the wires.
Clamp
Wall
Should not
be lifted.