Symbols Used; Intended Use - Truma S 2200 Einbauanweisung

Truma S 2200
Table of contents
Symbols used ...................................................................... 10
Intended use ..................................................................... 10
Installation instructions
Regulations ....................................................................... 11
Notes for the installer ..................................................... 11
1. Left or right exhaust duct connection ............................ 11
2. Exhaust gas system through side or rear wall ................ 11
3. Installation in the cabinet or free-standing in the room . 11
4. Installation with wall or roof cowl ................................... 11
- Notes on the wall cowl ..................................................... 11
- Notes on the roof cowl ..................................................... 12
5. Installation with or without warm air distribution ........... 12
Preliminary work .............................................................. 13
Installation with "installation box S 2200" .......................... 13
Free-standing installation in the room ................................ 13
Wall cowl installation ...................................................... 13
Drill holes for wall cowl ....................................................... 13
Duct connection to the heater ............................................ 13
Duct connection to the wall cowl ....................................... 13
Secure the wall cowl ........................................................... 13
Mounting the roof cowl .................................................. 14
Combustion air intake installation ....................................... 14
Installing the roof cowl ........................................................ 14
Exhaust duct mounting ....................................................... 14
Attaching the heater ....................................................... 14
Gas connection ................................................................. 14
Function check ................................................................. 14
Warnings ........................................................................... 14
Technical data ................................................................... 15
Dimensions ......................................................................... 15

Symbols used

Symbol indicates possible hazards.
Risk of burns! Hot surface.
Wear protective gloves to prevent possible mechanical
injuries.
Note containing information and tips.
EN
10

Intended use

Proper use
The appliance is approved solely for installation and operation
in caravans and construction trailers of vehicle class O and
mobile homes if the gas system is installed in accordance
with EN 1949. The national legislation and regulations for op-
erating and testing gas installations (e.g. DVGW Work Sheet
G 607 in Germany) must be observed.
The appliance may be used only to heat the vehicle's interior.
If the appliance is operated while the vehicle is in motion,
facilities must be installed to prevent uncontrolled emission
of liquefied gas in the event of an accident (according to
UN-ECE regulation 122).
If the appliance is being used for commercial purposes, the
operator must ensure that special statutory and insurance
regulations of the respective destination country are observed
(e.g. DGUV regulations in Germany).
Improper use
All other uses not listed under proper use are improper and
therefore prohibited. This applies for example to installation
and operation in:
- Motor homes (motor caravans) in vehicle class M1,
- Motor buses of vehicle classes M2 and M3,
- Commercial vehicles of vehicle class N,
- Boats and other water vessels,
- Hunting / forestry huts, weekend homes or awnings,
- Trailers and vehicles used by outdoor kindergartens.
Installation in trailers and vehicles used to transport hazard-
ous goods is prohibited
Defective appliances must not be used.
Appliances installed and utilised in contravention of the oper-
ating and installation instructions must not be used.