Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
6. Service
6.1. General
All maintenance activities must happen at an disconnected machine and hoses without pressure.
Allow to cool down the cleaner before performing maintenance activities!
Checking the electric components can happen exclusively by an expert. Exclusively accessories and replacement
components which have been approved by the manufacturer can be used. Directly after the activities all securi-
ties- and protection parts must be assembled, before the machine is put in functioning.
"a golden rule" that contributes to a perfectly working machine with few problems, is well the following:
A DAILY CONTROL AND CLEANING OF THE MACHINE FREQUENTLY DO WONDERS!
To be able to guarantee a perfectly working system, one has first necessary a reliable and technical well consid-
ered machine, which is then faced secondly at regular times with a thorough maintenance.
Therefore the experience and the "know-how" of DiBO a technical good working machine is insured and large
maintenance turns can be carried out by experienced DiBO technicians by means of appointment or maintenance
contract, we can suppose in advance that it is satisfied to these two points.
6.2. Maintenance diagram
6.2.1 General
Check daily by means of the maintenance diagram the high pressure cleaner.
You find the maintenance diagram on the following pages. Every other act has been prohibited!
The user of this manual may only do the maintenance activities described in detail further below.
If this case is not, then best consult the proper maintenance technicians.
6.2.2. Periodic maintenance
Check the electric cables, high & low pressure hoses, couplings and control
Extra control/replacement of joints, valves, o- rings & descaling of compo-
6.2.3. Control of oil level and refreshing pump oil
Check for each use of the machine, the oil with the oil level glass or with the oil level bar.
Oil must stand right with the sign of the oil level glass, if this is not, oil tops up until the sign.
If oil looks milky, consult directly the DiBO technicians. To refresh oil, work as follows:
- Unbolt the drain plug below the pump.
- Unbolt the tap with the oil level bar.
- Catch all oil in a barge and remove oil like further described in the guide.
- Force up the drain plug there and top up the oil in the breach to the upper part to on the mark line.
- Force up the tap with the oil level bar there.
6.2.4. Recommended lubricants
- Pump (+- 1Ltr, depending the pump)
6.2.5. Cleaning of the water filters
Clean the filter sieve (300 µ) of the water filter regularly, remove possible dirt.
Loosen the filter at the bottom of the trailer and clean it. If necessary, you can replace the sieve.
Pay attention: loosen the filter bowl carefully before replacing the sieve.
IBH-S: REV A
of the oil level.
Refreshing pump oil.
Cleaning water filter.
Replacement and cleaning fuel filters.
Cleaning fuel tank.
All following refreshments of pump oil.
nents by acknowledged DiBO- technicians!
: 1.836.042
After each use
First 50 hours
Each 50 hours/every month
First 50 hours, each follow-
ing 200 hours
First 50 hours, each follow-
ing 200 hours
Each 200 hours
Each 600 hours
DiBO n.v. 62
Werbung
Inhaltsverzeichnis
