Milling Tools - Protool RGP 80-8 E Bedienungsanleitung

After 3 to 5 minutes of cooling, the motor is ready
to be operated again and can be fully loaded.
ATTENTION! Do not ever operate the
machine when a defect of electronics has
occurred; an unwanted increase of revolu-
tions could occur. You may recognize a
defect of electronics by the fact that gradual
start-up is out of function or the number of
revolutions is impossible to be set.
Cutter head
Grinding head
Installation Application
Cutter head – Removing of butter ball (mineral plaster)
"Flat Shape" with – Removing of elastic protective coats on walls and
12 hard-metal
cutter wheels – Removing of foam base and glue remnants (carpet
FZ-RGP 80
– Removing of floor tile glue remnants
– Removing of bitumen and concrete protective coats
– Removing of latex paints or oil paints on gypsum
Cutter head – Removing of hard plaster (cement plaster)
"Pointed Shape" – Removing of bumps and excessive material after
with 12 hard-metal
cutter wheels – Removing of foam base and glue remnants (and
SZ-RGP 80
– Removing of floor tile glue remnants
– Removing of plaster made of synthetic resin (made
Installation Application
Diamond grinding – Removing of bumps and excessive material –
head: grinding
wheel with 8 – Grinding and cleaning weather-worn parts of
segments provided
with diamond grits – Removing of bumps – old concrete
DIA HARD-RGP 80
Diamond grinding – Removing of bumps and excessive material –
head: grinding
wheel with 8 – Grinding and cleaning – fresh concrete
segments provided – Grinding – abrasive materials
with diamond grits
DIA ABRASIVE-
RGP 80
Hard-metal grinding – Removing of elastic protective coats on walls and
head: grinding
wheel provided with – Reduction of gypsum and cellular concrete
hard-metal grits – Removing of impurities – concrete floors
HW GROB-RGP 80 – Removing of latex or oil paints – gypsum surface
– Rough working

Milling tools

Choice of cutter and grinding head
According to use and type of application, there
are various types of cutter heads. To achieve
optimal work results, use suitable grinding heads.
Data in the Chart showing speed pre-selection
options are recommended values only; practice
testing should be always performed!
flooring
remnants)
surface
boarding – fresh concrete work
carpet remnants)
on thermal insulation)
screed floor cover
concrete constructions
screed floor cover
flooring
Electronic
adjusting
wheel
4. – 6.
4. – 6.
Electronic
adjusting
wheel
3. – 4.
3. – 4.
1. – 2.