Operation; Specifications - Ingersoll-Rand SRA010A1-EU Bedienungsanleitung

OPERATION

Make direct cuts into wood or comparable material
as shown in the following illustrations:
1. Hold the saw as shown in Figure 1 with the Saw Guide
firmly against the material and the tip of the Blade
above the material. Press the Trigger.
Figure 1
2. Raise the handle of the Saw, bringing the tip of the
Blade in contact with the material. See Figure 2.
Figure 2
Model Length of
Stroke
in
SRA010A1–EU 5/8
SRA010K2–EU 5/8
G
Tested in accordance with ANSI S5.1–1971 at free speed
♦ Tested in accordance with ISO8662–1 while cutting
•
ISO3744
PLACING TOOL IN SERVICE

SPECIFICATIONS

Strokes per
minute
mm
16 1,600
16 1,600
3. Raise the Saw slowly to an upright position, keeping
the Saw Guide firmly against the material. Guide the
Saw in this position along the direction of the cut.
4. When cutting metal from an edge, hold the Saw as
shown in Figure 3, keeping the Saw Guide firmly
against the work to prevent vibration of the metal and
blade chattering. When making direct cuts into metal,
first chisel or drill a starting hole.
GSound Power Level
dB (A)
Pressure
86.0
86.0
3
Figure 3 (Dwg. TPD1194)
♦Vibrations
Level
•Power
2
m/s
99.0 5.4
99.0 5.4