Waeco MAGIC WATCH MWE-1000-4FM Bedienungsanleitung Seite 43

_MWE-1000-4FM.book Seite 43 Dienstag, 9. August 2005 11:30 11
magic watch
Connecting the power supply
➤ Guide the connection cable (5 3, page 5) to the control electronics and
plug the plug onto the connection on the control electronics (i, page 9).
Make sure the locking pin catches.
➤ Connect the red cable (h 3, page 8) on the control box to the positive
wire (+) of the reversing light (h 2, page 8).
➤ Connect the black cable (h 4, page 8) to the earth wire (-) of the
reversing light or to earth (bodywork).
Connecting the sensors
The sensor plug polarities cannot be reversed: they can be only
be plugged into the connection in one way.
The arrow on the sensors must be visible on top.
You must connect the sensors to the electronic controller as
shown in the following table. Otherwise MAGIC WATCH will not be
able to display the direction of the obstacles correctly.
Connection in the
electronic controller
1
2
3
4
The sensors are numbered from 1 to 4. Connect the sensors to
the appropriate connection in the control electronics.
➤ Insert the plugs of the sensor cables into the corresponding sockets of the
electronic controller (j, page 9).
Make sure the locking pin catches.
The "Buzzer" connection on the electronic controller remains free.
Description
Outside right sensor (d 1, page 7)
Inside right sensor (d 2, page 7)
Inside left sensor (d 3, page 7)
Outside left sensor (d 4, page 7)
Installing MAGIC WATCH
43