Herunterladen Inhalt Inhalt Diese Seite drucken

Before First Use; Filling The Salt Reservoir; Setting The Salt Consumption - Inventum IVW6033A Gebrauchsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

3

before first use

Prior to using the machine for the first time please check whether the electricity and supply water specifications match the
values indicated by the installation instructions for the appliance.
Remove all packaging materials inside the machine.
Fill the salt reservoir and fill up with water until it almost overflows. Set the water hardness setting.
Fill the rinse aid reservoir.

FILLING THE SALT RESERVOIR

For a good washing result, the dishwasher needs soft, i.e. less calcareous water. Otherwise, white lime residues will remain
on the dishes and the interior of the dishwasher. This has a negative effect on your applinace's washing, drying and shining
performance. For this purpose, dishwasher salt is used.
• Remove the lower basket and unscrew the cap of the salt reservoir (1 and 2).
• Fill the reservoir before first use with 1 litre of water (3). Place a funnel into the
opening and fill with salt till the overflow level (4).
It is normal for a little water to flow out of the opening when doing this.
• Screw the cap back on firmly.
ATTENTION!
• Remove any spilled salt and run a full program to prevent corrosion to the
bottom.
• Refill the salt reservoir when the indicator light of the salt reservoir lights up.

SETTING THE SALT CONSUMPTION

To find out the water hardness level in your area, contact your local water company. Adjust the salt consumption according
to the table on the next page.
Note! Hardness level is adjusted to level 3 as a factory setting.
• Move the program selector knob (1) to the setting off ● while the dishwasher is not on.
• After setting the program selector knob to off ● , press the Start/Pause button (2) and keep it pressed down.
• Turn the program selector knob to the first program Rinse while still pressing the Start/Pause button (2).
• Keep the Start/Pause button (2) pressed down until the indicator lights turn on and off.
• After the indicator lights (3) lit up, release the Start/Pause button (2).
The control panel shows the latest entered water hardness setting.
• Set the level of water hardness by pressing the Start/Pause button (2). Use the table of water hardness level
settings on the next page.
• After adjusting the level of water hardness, turn the program selector knob back to the setting off ● to confirm and
store the setting.
1
3
2
4
3
1
2
English
29

Werbung

Inhaltsverzeichnis

Fehlerbehebung

loading

Inhaltsverzeichnis