Before First Use; Filling The Salt Reservoir; Setting The Salt Consumption - Inventum IVW4508A Gebrauchsanleitung

3

before first use

Prior to using the machine for the first time please check whether the electricity and supply water specifications match the values
indicated by the installation instructions for the appliance.
Remove all packaging materials inside the machine.
Fill the salt reservoir and fill up with water until it almost overflows. Set the water hardness setting.
Fill the rinse aid reservoir.

FILLING THE SALT RESERVOIR

For a good washing result, the dishwasher needs soft, i.e. less calcareous water. Otherwise, white lime residues will remain on the
dishes and the interior of the dishwasher. This has a negative effect on your applinace's washing, drying and shining performance.
For this purpose, dishwasher salt is used.
• Remove the lower basket and unscrew the cap of the salt reservoir (1 and 2).
• Fill the reservoir before first use with 1 litre of water (3). Place a funnel into the
opening and fill with salt till the overflow level (4).
It is normal for a little water to flow out of the opening when doing this.
• Screw the cap back on firmly.
ATTENTION!
• Remove any spilled salt and run a full program to prevent corrosion to the
bottom.
• Refill the salt reservoir when the indicator light of the salt reservoir lights up.

SETTING THE SALT CONSUMPTION

To find out the water hardness level in your area, contact your local water company. Adjust the salt consumption according to the
table on the next page.
Note! Hardness level is adjusted to level 3 as a factory setting.
1
• Press the program selector button and keep it pressed down while the dishwasher is not on (2).
• In the meanwhile switch on the dishwasher by pressing the On/Off button (1).
Keep the program selector button (2) pressed down until SL disappears from the display.
•
• Release the program selector button (2). The control panel shows the latest entered water hardness setting.
• Set the level of water hardness by pressing the program selector button (2). Use the table of water hardness level
settings on the next page.
• After adjusting the level of water hardness, press the On/Off button (1) to confirm and store the setting.
32
• English
IVW4508A-instructions.indd 32
1
2
2
3
4
1-8-2018 09:33:12