Items Supplied; Before Using For The First Time - Silvercrest SGS 100 A1 Bedienungsanleitung

Lay the power cable such that no one
can step on it, get caught on it, or trip
over it.
Only connect the mains plug to a prop-
erly installed and easily accessible wall
socket whose voltage corresponds to
the specifications on the rating plate.
The wall socket must continue to be eas-
ily accessible after the device is
plugged in.
Ensure that the power cable cannot be
damaged by sharp edges or hot points.
Do not wrap the power cable around the
device (Danger! Risk of cable damage!).
Ensure that the power cable cannot be
trapped or crushed.
To pull the mains plug out of the wall
socket, always pull on the mains plug,
and never on the power cable.
Disconnect the mains plug from the wall
socket,...
... after every use,
... if there is a fault,
... when you are not using the device,
... before you clean the device and
... during thunderstorms.
DANGER! Fire hazard!
Never leave the device unattended
while it is plugged in.
Never heat the device if it doesn't con-
tain any water.
DANGER! Risk of injury
through burning/scalding
The water is boiling in the water con-
tainer during operation. Any contact
with boiling water or hot steam may
cause serious injury.
Do not touch the hot inner parts of the
device.
Allow the device to cool down com-
pletely before you transport or clean it.
Allow all parts to cool down before re-
moving them from the device.
6
GB
WARNING! Risk of material damage
Use the original accessories only.
Never place the device on hot surfaces
(e.g. hob plates) or near heat sources or
open fire.
Do not use any astringent or abrasive
cleaning agents.
Do not expose the device to tempera-
tures below -10 °C or above +40 °C.

4. Items supplied

1 base unit 6
1 face mask with aroma reservoir 1
1 nose mask 2
1 aroma reservoir for the nose mask 4
1 lid for the aroma reservoirs 3
1 measuring beaker 9
1 operating instructions
5. Before using for the
first time
• Remove all packing material.
• Check that the device is undamaged.
• Clean the device prior to its first
use ! (see "Cleaning" on page 10)
• Place the device on level, water insensi-
tive and (to the maximum extent possi-
ble) non-slip ground.
• Select the location such that you can
comfortably sit in front of the device.