Technical Data; General Power Tool Safety Warnings; Work Area Safety - Parkside PEH 30 C3 Originalbetriebsanleitung

Technical data

Rated voltage:
Nominal output:
Rated idle
speed:
Plane width:
Cut depth:
Fold depth:
Protection class:
Noise and vibration data:
Noise measurement value determined in accordance
with EN 60745. The A-rated noise level of the
power tool is typically as follows:
Noise emission value:
Sound pressure level:
Sound power level:
Uncertainty:
Wear hearing protection!
Total vibration value:
Handle:
Additional handle:
Uncertainty:
NOTE
► For an accurate estimate of the vibration load
during a specific working period, the periods
during which the appliance is switched off or
is running but not actually being used must
also be taken into consideration. This can
significantly reduce the vibration load over the
total working period.
► The vibration emission values and the noise emis-
sion values given in these instructions have been
measured in accordance with a standardised
test procedure and can be used for comparison
of the power tool with another tool.
► The specified total vibration values and the
noise emission values can also be used to
make a provisional load estimate.
PEH 30 C3
230 V ∼ 50 Hz (AC)
750 W
n 13000 rpm
0
82 mm
0–3 mm
max. 24 mm
II / (double insulation)
L = 96.6 dB(A)
PA
L = 107.6 dB(A)
WA
K = 3 dB
a = 10.8 m/s 2
h
a = 8.8 m/s 2
h
K = 1.5 m/s 2
WARNING!
► Depending on the manner in which the power
tool is being used, and in particular the kind
of workpiece that is being worked, the vibra-
tion and noise emission values can deviate
from the values given in these instructions
during actual use of the power tool. Try to
keep the vibration loads as low as possible.
Measures to reduce the vibration load are,
e.g. wearing gloves and limiting the working
time. Wherein all states of operation must be
included (e.g. times when the power tool is
switched off and times where the power tool
is switched on but running without load).
General power tool
safety warnings
WARNING!
► Read all safety warnings, instructions, il-
lustrations and specifications provided with
this power tool. Failure to follow all instruc-
tions listed below may result in electric shock,
fire and/or serious injury.
Save all warnings and instructions for future
reference.
The term "power tool" in the warnings refers to
your mains-operated (corded) power tool or bat-
tery-
operated (cordless) power tool.

1. Work area safety

a) Keep work area clean and well lit.
Cluttered or dark areas invite accidents.
b) Do not operate power tools in explosive atmos-
pheres, such as in the presence of flammable
liquids, gases or dust. Power tools create sparks
which may ignite the dust or fumes.
c) Keep children and bystanders away while
operating a power tool. Distractions can cause
you to lose control.
GB │ IE │
15 ■