Blade Und Clipper/Trimmer Repair Service - Trixie TR1500 Gebrauchsanweisung

blades, put the smaller, upper blade back into position (Figure F). Line up the screw holes in
the bottom blade with the two holes in the clipper housing, and replace the screws. Do not
tighten down the screws completely. Turn the clipper over and align the lower blade so the
teeth on both blades are parallel, but with the lower blade's teeth slightly above the upper
blade's teeth. Failure to do this may result in nipping the skin when cutting the hair.

Blade und Clipper/Trimmer Repair Service

When the blades of the clipper/trimmer TR1500 become dull after repeated use, it is advised
to purchase a new set of blades available through your supplier. Some blade sets can be
resharpened - contact your supplier or the TRIXIE Heimtierbedarf GmbH & Co. KG for in-
formation on resharpening. If you wish your clipper/trimmer to be serviced as well, contact
your supplier.
Disposal in EU countries
Follow the appropriate laws and regulations for the disposal of the device. Information for
the disposal of electric and electronic devices in the European Union: In the European Union
the disposal of electric devices is regulated nationally, based on the EU-guideline 2012/19/
EU for Waste Electrical or Electronic Equipment (WEEE). Accordingly, this device may not be
disposed of through the community or domestic waste collection services. This
device will be accepted at community collection points or recycling yards free of
charge. The product packaging consists of recyclable materials. Dispose of these
properly to protect the environment and ensure it can be reused or recycled.
Dispsal in non-EU countries
Please dispose of the device at the end of its service life in an environmentally friendly way
and according to the legal requirements.
CAUTION: Never handle your clipper TR1500 while you are operating a water faucet and
never hold your clipper under a water faucet or in water.
There is danger of electrical shock and damage to your clip-
per. The TRIXIE Heimtierbedarf GmbH & Co. KG will not be
responsible in case of injury due to this carelessness.
Basic Instructions for Fur Care
Best Conditions for Clipping
• Prepare a stable and non-slip work area on a table.
• Get your pet/your dog acquainted to the clipper:
·Step 1: Switch the device on while feeding or playing for several days before the clipping.
That way, you pet can get used to the sound first and connects it to something positive.
12