INVENTOR V5MKI32-18WiFiR/U5MRS32-18 Installationshandbuch Seite 24

Table 8.2: Other Regions
Rated Current of Appliance (A)
≤6
6-10
10-16
16-25
25-32
32-45
b. Using wire strippers, strip the rubber jacket
from both ends of a signal cable to reveal
about 15cm (5.9") of the wires inside.
c. Strip the insulation from the ends of the
wires.
d. Using a wire crimper, crimp u-lugs on the
ends of the wires.
NOTE: While connecting the wires, strictly
follow the wiring diagram (found inside the
electrical box cover).
2. Remove the electric cover of the outdoor
unit. If there is no cover on the outdoor unit,
disassemble the bolts from the maintenance
board and remove the protection board. (See
Fig. 8.1,8.2)
Protection Board
3. Connect the u-lugs to the terminals
Match the wire colors/labels with the labels on
the terminal block and firmly screw the u-lug of
each wire to its corresponding terminal.
4. Clamp down the cable with the designated
cable clamp.
5. Insulate unused wires with electrical tape. Keep
them away from any electrical or metal parts.
6. Reinstall the cover of the electric control box.
◄ Page 24 ►
Nominal Cross-Sectional
Area (mm )
2
0.75
1
1.5
2.5
4
6
Cover
Screw
Fig. 8.1
Fig. 8.2
Indoor Unit Wiring
1. Prepare the cable for connection
a. Using wire strippers, strip the rubber jacket
from both ends of a signal cable to reveal
about 15cm (5.9") of the wires inside.
b. Strip the insulation from the ends of the
wires.
c. Using a wire crimper, crimp the u-lugs to the
ends of the wires.
2. Open the front panel of the indoor unit. Using
a screwdriver,remove the cover of the electric
control box on your indoor unit.
3. Thread the power cable and the signal cable
through the wire outlet.
4. Connect the u-lugs to the terminals.
Match the wire colors/labels with the labels on
the terminal block and firmly screw the u-lug of
each wire to its corresponding terminal. Refer to
the Serial Number and Wiring Diagram located
on the cover of the electric control box.
wire outlet
control box
Wiring diagram
Magnetic ring (if supplied and packed with the
accessories)
Connective wiring diagram
Fig. 8.3
Pass the belt
through the hole
of the Magnetic
ring to fix it on the
cable
Fig. 8.4