Husqvarna T435 Bedienungsanweisung Seite 13

1. Move the front hand guard forward to engage the
chain brake.
2. Push the air purge bulb about 6 times or until fuel
starts to fill the bulb. It is not necessary to fill the air
purge bulb fully.
To start the product on page 13 for
3. Continue to
more instructions.
To start the product
WARNING: You must keep your feet in a
stable position when you start the product.
WARNING: If the saw chain rotates at idle
speed, speak to your servicing dealer and
do not use the product.
1. Put the product on the ground.
2. Put your left hand on the front handle.
3. Put your knee on the rear part of the top handle.
733 - 002 -
4. Pull the starter rope handle slowly with your right
hand until you feel resistance.
WARNING: Do not twist the starter cord
around your hand.
CAUTION: Do not pull the starter rope to
full extension and do not let go of the
starter rope handle.
a) If you start your product with a cold engine, pull
the starter rope handle until the engine fires.
Note: You can identify when the engine fires
through a "puff" sound.
b) Put the choke control in choke position.
5. Pull the starter rope handle until the engine starts.
6. Quickly disengage the throttle trigger lockout to set
the product to idle speed.
7. Move the front hand guard rearward to disengage
the chain brake.
8. Use the product.
13