Initial Startup - AL-KO Highline 51.6 SP-B Plus Betriebsanleitung

G B
I n it i a l s t a r t u p
C au tio n !
A
T h e equipm ent should not be used if the cutting
gear and /or fastenings are loose, dam ag ed or
worn.
Carry out a visual inspection before each start-
up.
K * 1 T h e cam era symbol on the following pag e refers
to the illustrations on P ag e 4 -7 .
A d ju s t in g t h e c u t tin g h e ig h t
C au tio n - R isk o f inju ry!
Adjust the cutting height only with the m otor
switched off and w hen the m ow er blade has
com e to a standstill.
 Always set all the w heels to the sam e cutting
height.
 Cutting height adjustm ent depends on the
particular model.
C en tra l a d ju s tm e n t (CJ 1)
1. Press and hold th e central height adjustm ent knob
(C l 1/1).
 For shorter grass, press the central adjustm ent
handle downward ( O 1/2)
 For longer grass, pull th e central adjustm ent
handle upward ( n 1/2)
 T h e central height adjustm ent level is indicated
1/3)
(Cl
2. R elease the knob at the desired cutting height.
A x le a d ju s tm e n t o r ce n tral a d ju s tm e n t ( O 2, 3)
1. To release the lever, press to the side and hold.
2. Push the lever to the left or right to select the
desired cutting height.
3. Let the lever click into position.
4. Check that all w heels are set to the sam e position.
26
Q u ic k a d ju s tm e n t o f in d iv id u a l w h ee ls
o r ax le a d ju s tm e n t 4)
(CJ
1. To release the lever, press to th e side and hold.
2. Push the lever to the left or right to select the
desired cutting height.
3. Let th e lever click into position.
4. C heck th at all w heels are set to the sam e position.
In d iv id u a l w h e e l a d ju s t m e n t ( a 5)
1. Loosen th e wheel bolt.
2. Insert the w heel bolt in the hole corresponding to
the desired cutting height.
3. Tighten the wheel bolt.
4. C heck th at all w heels are set to the sam e position.
C e n tr a l a x le a d ju s t m e n t ( c i 6)
1. P lace a thumb at each end of the axle.
2. P lace the fingers under the m ow er housing.
3. Using both thum bs, press th e axle out of its present
height setting notch.
4. Using both thum bs, push th e axle to th e desired
height setting notch, then allow it to engage.
5. C heck th at all w heels are set to the sam e position.
Translation o f original user instructions
Petrol law nm ow er