Headless Mode - ACME Payload Bedienungsanleitung

3d roll
Press down the 3d rolling button and
push the right control stick to the top/
bottom/leftmost/rightmost at the same
time, and the drone will roll as per the
control signal from the remote control.

headleSS mode

enter into headleSS mode
once the signal of the drone and the remote control are
successfully connected, press the function button located at the
top left of the remote control for 2 seconds. the remote controller
will send out two beep sounds and the words "stick mode" will
flash on the lcd screen, while the drone's indicator light will
change from constantly "on" to "flashing". this means the drone
is in headless mode.
drone caliBration in headleSS mode:
When the drone is in headless mode, a drone calibration is
needed. Position the drone in such a way that its front is facing
your front, then turn both of the two control sticks to the lower right
corner for about 2 seconds. the drone's indicator light will change
from slowly flashing to quick flashing and the drone calibration is
then finished.
flight direction control in headleSS mode
• When checking on the flight direction of the drone, set the drone's nose right ahead and its tail facing the pilot. At this time, the drone's nose is pointing forward – this
direction will be constantly considered as "forward" when the forward signal is given from the remote control, no matter where the drone's nose is pointing. that is to
say, the pilot's straight front side is defined as "forward"; the pilot's back side is defined as "backward"; the pilot's left side is defined as "left"; and the pilot's right side
is defined as "right".
• When the drone is flying in headless mode, the pilot should keep facing the forward direction. Otherwise, the drone will be out of control. The drone controls are shown
below:
exit headleSS modee
When the drone is in headless mode, press the function
button
at the top left of the remote control for 2 seconds. the remote
controller will send out 3 beep sounds and the words "stick
mode" will stay constantly "on", while the drone's indicator
light will change from flashing to constantly "on". this means
the drone has exited the headless mode.
Pic. 20
Pic. 19
Pic. 21
9