Bodum 11659 BISTRO Gebrauchsanweisung Seite 7

HOW TO USE THE
KETTLE
Filling the kettle
Remove the kettle from its base (6).
Open the lid (1), fill the kettle with water to the desired level
then close the lid (1). The kettle must contain a minimum of
0.25 l (5) and should be filled no higher than the MAX mark
(4). This prevents it from switching off before the water has
boiled or reached the required temperature.
Connecting to the electrical supply
After filling the kettle, place it on its base (6). Check the kettle
is properly seated on the base (6).
Connect the kettle to the electrical supply; an acoustic signal
indicates that it is ready.
Now select the required water temperature by turning the
temperature selection knob (8)
and press the on/off button (7). This will flash until the water
either reaches the required temperature or boils, at which
point it will extinguish.
An acoustic signal indicates when the water has reached the
selected temperature. The water can now be used.
Note: to change the required temperature of the water while
it is heating, simply turn the temperature selection knob (8).
Note: different teas require different brewing temperatures.
Brewing a delicate variety at too high a temperature can
make it taste bitter. The BODUM® water kettle with adjustable
temperature settings is ideally suited to preparing any type
of tea. There are five temperature settings to choose from.
(60°C; 70°C; 80°C; 90°C and boil)
«Keep warm» function
To keep the water at the required temperature for 30
minutes, press the «keep warm» button (9).
The «keep warm» button (9) will remain illuminated until
the kettle is removed from its base (6), the button is pressed
again, or 30 minutes have expired.
Note: The «keep warm» function only works in combination
with ON/OFF-button (7). The «keep warm» button (9) can be
pressed before switching the kettle on (You need to press the
ON/OFF button (7) within 5 seconds after pressing the «keep
8
EN