Maintenance And Repair - Amprobe 2100-Beta Bedienungsanleitung

Rotary field Detection
Voltage range
frequency range
LED indication
General Specifications
operating
temperature
range
Storage
temperature
range
Humidity
operating
altitude
Measurement
category
Pollution degree
IP Protection
Safety
regulations
Agency approval
Power Supply
Power
consumption
Battery lifetime
Dimensions
(HxWxD)
Weight

MAInTEnAncE AnD REPAIR

According to the operating instructions the
voltage testers do not require any special
maintenance for operation. However, if a
malfunction occurs during operation, the
measurement has to be stopped and a
further measurement is not allowed. The
unit has to be tested at our factory service
department. Except for the replacement of
the battery, repair of the instrument should
be performed only by an Authorized Service
Center or by other qualified instrument
service personnel.
W
If the instrument is not used for a
prolonged period, the batteries must be
removed, as leaking batteries may be
hazardous and cause damages.
cleaning
Before cleaning, disconnect the voltage
testers from all measuring circuits. If the
instruments have become dirty due to daily
use, they can be cleaned with a damp cloth
and a little mild household detergent.
Never use aggressive detergents or solvents
for cleaning. After cleaning, do not use the
instrument until it is completely dry.
340...440 V AC phase
to phase
47 Hz...63 Hz
Red LED
-15°C to +55°C
-15°C to +55°C
Max. 95% RH
Up to 2000 m
CAT IV 600V,
CAT III 690V
2
IP 64
EN 61243-3:2010
GS from TÜV
Rheinland, CE
2x 1.5V (AAA/ IEC
LR03)
Approximately 60 mA
More than 10000
measurements
(<5 s / per measurement)
Approximately 280 x
78 x 35 mm (11.0 x 3.1
x 1.4 in)
Approximately 320 g
(0.71 lb)
9