Wiring Connections For Acm500 Options - Mettler Toledo ACM500 Installationsanleitung

3.6.

Wiring Connections for ACM500 Options

Options available for the IND560x terminal that are installed in the ACM500 and require external
connections include the following:
Figure 3-14 shows where each of these options is located in the AMC500. The connections for
each of these options are described in the following sections.
3-12 METTLER TOLEDO ACM500 Installation Manual
Wire end ferrules with plastic
collar, crimp connection required
for some regions
IMPORTANT: Apply the cable shielding only on the IND560x end. Do NOT apply shielding
on the ACM500 end of the current loop connection cable.
BEFORE PUTTING THE ACM500 INTO SERVICE, MAKE SURE THE PROTECTIVE COVER IS
INSTALLED PROPERLY OVER THE INTERFACE BOARD. THIS PROTECTIVE COVER IS PART OF
THE SAFETY APPROVAL FOR THE ACM500 CONNECTIONS INTO THE HAZARDOUS AREA. NO
WIRES FROM THE COM4 OR COM5 CONNECTION CAN CONTACT THE ACM500 MAIN BOARD
OR ANY OF THE OPTION BOARDS.
• Ethernet and COM2/COM3 Serial Ports
• DeviceNet
• PROFIBUS DP
Figure 3-13: I.S. Serial Interface Wiring
WARNING
• Analog Output
• Allen-Bradley (A-B) RIO
• EtherNet/IP and Modbus TCP
64061976 | 07 | 01/2019