Flex S 203 BVE Bedienungsanleitung Seite 17

Pendulum-stroke jigsaw S 203
Adjusting the saw bench
1. Pull out the mains plug.
2. Remove the dust cover to the front.
3. Remove the anti-splinter shoe.
4. Loosen the clamping screw with the
key 7.
5. Pull back the saw bench slightly and
set the required bevel:
for 15/30/45° diagonal cuts as well as for
resetting to 0°:
– there are notches on the power tool,
push the saw bench forwards.
For all other angles:
– Set the angle according to the scale or
with a measuring device, do not push
the saw bench forwards.
6. Retighten the clamping screw.
Note
For diagonal cuts use the dust cover with
bevel 1 b.
Attaching the anti-splinter shoe
1. Pull out the mains plug.
2. Slide the anti-splinter shoe 13 with the
grooves onto the front of the saw bench.
Note
The anti-splinter shoe cannot be used with
special saw blade shapes.
Dust extractor
The jigsaw can be connected to an extractor
(inner hose diameter 25 mm) with the
adapter for the dust extractor 6.
– Slide the adapter from the rear until it
locks into position in the power tool.
– To remove the adapter, press the
catches on the adapter and pull out.
Stroke rate (cutting speed)
The stroke rate can be adjusted steplessly
to the material requirements with the
adjusting wheel 2.
– Position A = 380 strokes/minute
– Position G = 3200 strokes/minute
Pendulum stroke
The pendulum stroke can be adjusted with
the adjusting knob 8.
– Position 0 = pendulum stroke off
– Position III = maximum pendulum stroke
Material
Wood
Steel
Aluminium
Ceramic
Rubber
Stroke Pendulum
rate stroke
G I–III
D–E 0
E 0–I
B–C 0
A–C 0
17