Connection And Control Devices; Operation - ESAB Caddy Mig C200i Betriebsanweisung

GB
6.1

Connection and control devices

1
Mains supply switch
2
LCD, see 6.2.1 & 6.2.2
3
Welding torch
2
3
4
6.2

Operation

Once the machine is turned--on, it is not powered instantly. Approximately 2 seconds
after switching the machine on by means of the mains switch , the LCD display
indicates that the machine is ready.
The machine is protected against welding start during power on. If the torch
pushbutton is pressed while the machine is being turned--on, the operation is
disabled, until the torch button is released.
The return cable must be reliably connected to the workpiece or to the welding table.
The wire spool section must be closed prior to the welding.
Machine is instantly switched off by means of the mains switch.
C200ie
4
Return cable
5
Mains cable
6
Gas connection
1
6
5
- - 62 - -