Basic Settings - MTR+ DuoBravo Bedienungsanleitung

In all programs, even in the preset programs, individual settings can be made as follows.
After you have put in four batteries type AA (s.p. 63) and you have turned on the device with
the ON/OFF-button, you enter the configuration mode by pressing the SET button in the
battery compartment for three seconds. Now you can adjust the settings for the first phase of
the selected program. To configure the next phase, SET should be pressed again.
The parameter that can be changed is shown in the info line and can be altered by pressing the
+ button of channel B. Pressing the + button of channel A will confirm the choice and the next
variable parameter is displayed. This system - changing settings with B / storage and stepping
forward with A - remains always the same during the entire process.
Please note that the following settings you make here, are automatically stored for all
subsequent phases and all other programs as well. Of course you can change any setting at any
time in the same way again.
STIM-phases
- Channel B can be switched on or off.
- In phases with work/rest-rhythm it can be decided
a) whether EMG shall be measured during the rest-period and
b) which filter shall be used
- PC-connection can be chosen or switched off.
EMG-phases or ETS-phases
- Sound-volume
- Automatic threshold-adjustment on or off
- Wide- or narrow-filter for channel A
- Channel B switched on or off
- Filter for channel B if it is in use
- PC-connection can be chosen or switched off
In the customizable programs PC1 - PC4 of course you have the chance to determine numerous
parameters more in the same way as described before (s.p. 75-79).
DuoBravo Bedienungsanleitung / Operators Manual

Basic Settings

67