Troubleshooting; Bluetooth Wireless Technology - Muji MJBTS-1 Bedienungsanleitung

Troubleshooting (1)

If you should have any trouble with this unit please
review the following information.
If it still does not function properly, please contact the
retailer where you purchased the unit.
General
The unit does not work.
e Plug the dedicated AC adaptor into an outlet that
is supplying power.
e Check the connection between the power cord
and dedicated AC adaptor cord.
e Change the battery in the remote control.
There is no sound.
e Adjust the volume.
The remote control does not work.
e An isolation sheet is inserted in the battery com-
partment when shipped from the factory. Pull it out
before use. For details, see page 11.
e If the battery is dead, replace it with a new one.
e Use the remote control from a distance of 5 m or
less, and point it at the main unit.
e If any obstruction is between this unit and the
remote control, operation might not be possible,
so change positions as necessary.
e If a bright light is near the unit, turn it off.
The sound is noisy.
e Locate the unit as far as possible from televisions,
microwaves and other devices that produce elec-
tromagnetic waves.
Radio
Station cannot be tuned or its reception is poor.
e Change the position of the FM antenna.

Bluetooth wireless technology

Unable to pair with a Bluetooth device.
e Refer to the operation manual of that Bluetooth
device.
e Turn both this unit and the other Bluetooth device
off once and then turn them on and try pairing
again.
e Turn off the Bluetooth devices other than the one
that you are trying to pair with the unit.
e Make the Bluetooth device delete (forget) the
"MJBTS-1" pairing and then try pairing again. (See
"Pairing with a Bluetooth device" on page 14.)
Unable to connect.
e Confirm that the Bluetooth device is on and that
its Bluetooth function is on.
e Is the Bluetooth device too far away? Is there a
wall or other obstruction between the unit and
that device?
e Turn this unit off and then on again.
e Make the Bluetooth device delete (forget) the
"MJBTS-1" pairing and then try pairing again. (See
"Pairing with a Bluetooth device" on page 14.)
Continued on the next page
19