Maintenance - HSM 411.2 Betriebsanleitung

HSM 411.2
Electric motor overheated
Red LED on membrane keyboard lights
• Paper shredder switches off automatically
Allow paper shredder to cool down for approx. 15 to 20 min.
Open the front door or the inspection door on the top of the machine
Red LED on membrane keyboard lights
• Paper shredder stops automatically
Close front door and inspection door
Bag for shredded material full
Red LED on membrane keyboard lights
• Paper shredder stops automatically
Insert new bag
Particle cutting devices are equipped with a compacting mechanism. Press
the foot pedal in the lower part of the cabinet to shake up the collector sack
and reduce the volume of the particles. Paper can be fed again.
CAUTION!
Empty the shredded material container after the paper shredder has been
switched off, because otherwise malfunctions of the cutting system could
occur when the rocker switch is pressed several times in succession.

11. Maintenance

When the cutting capacity drops or the noise increases:
Lift the inspection door on the top of the device and spray special cutting
block oil on the blade rollers of the cutting device
Run cutting system forwards and backwards several times without feeding
paper
• Paper dust and particles are shaken off
24
Paper shredder
GB
01/02