Selecting A Radio Channel; Interference Eliminator Code; Scan; Nuisance Delete - Motorola T5622 Betriebsanleitung

6864227V01-A_EN.fm Page 8 Thursday, April 6, 2006 2:37 PM

Selecting a Radio Channel

1.Press \ . The channel number will begin to flash.
2.Use ] or [ to change channel.
3.Press M to set new channel.

Interference Eliminator Code

Interference eliminator codes help minimize
interference by providing you with a choice of code
combinations.You can specify a different code for each
channel.
1.Press \ until the code number begins to flash.
2.Use ] or [ to change the code.
3.Press M to set new code.
You can specify a different code for each channel:
1.To set a channel and code combination, press
and then press ] or [ to select the channel.
2.Press \ again and then press ]
a code.
3.Press M or press and hold \ to exit the menu
and to save the channel and code combination.
4.To set another channel and code combination,
repeat these steps.
8

Scan

1.To start scanning, briefly press and release the
Jbutton.
2.If you activate scan while your code is set to 0, then
the radio will check for any activity on each channel,
regardless of the code in use on that channel.
3.If you activate scan while the code is set on 1 to 38,
the radio will only check for activity on the specific
channel and code combinations that are set on your
radio.
4.While the radio is scanning,
the radio will scroll through the channels.
5.When activity is detected on a channel, the radio will
stop scanning and you will hear whatever transmis-
sions are detected. The radio's display will show the
channel and code on which activity was detected.
6.If you want to respond to the transmission, press M
within 5 seconds.
\
7.The radio will resume scanning after 5 seconds of
inactivity on the channel.
or [ to select
8.If scan stops on a channel that you don't want to lis-
ten to,briefly press
]
the next active channel.
9.To stop scanning, briefly press and release

Nuisance Delete

1.If scan continuously stops on an undesired channel,
press and hold
]
release. This will temporarily remove the undesired
channel from the scan list.
h will be displayed and
or to resume scanning for
[
.
J
or for at least 3 seconds, then
[