Bluetooth ® Pairing - Hama Tour ANC Bedienungsanleitung

Note
• The Bluetooth connection remains available during
®
charging.
• If the battery level is low when using the headset, a voice
says 'Low Battery'. Connect the headset to a suitable USB
port using the charging cable.
5. Operation
Switching the headset off/on
• Press and hold the MFB button (6) for about 3 seconds until
a voice says 'Hello' and the LED (5) flashes alternating red
and blue.
• To switch the device off, press and hold the MFB button (6) for
about 5 seconds until a voice says 'Goodbye' and the red LED
(5) flashes and goes out.
Note
The functions described in this section are only available for
Bluetooth -capable terminal devices.
®
5.1. Bluetooth pairing
®
Note – Pairing
• Make sure that your Bluetooth
on and Bluetooth is activated.
®
• Make sure that your Bluetooth
visible for other Bluetooth
• For more information, please refer to the operating
instructions of your terminal device.
• The headset and the terminal device should not be any further
than 1 metre away from each other. The smaller the distance,
the better.
• Switch the headset on using the MFB button (6).
• Press and hold the MFB button (6) for about 5 seconds until a voice
says 'Hello' and the LED (5) flashes alternating red and blue. The
headset is searching for a Bluetooth
• Open the Bluetooth settings on your terminal device and wait
®
until Hama BTH TOUR ANC appears in the list of Bluetooth
devices found.
• Select Hama BTH TOUR ANC and wait until the headset is listed
as connected in the Bluetooth
-capable terminal device is
®
-capable terminal device is
®
devices.
®
connection.
®
settings on your terminal device.
®
Note – Bluetooth
Some terminal devices require a password in order to connect
to another Bluetooth
• If your terminal device requests a password for connection
with the headset, enter 0000.
Note
• If the connection was successful, the LED (5) flashes and a
voice says 'Your device is connected'.
• If the connection attempt takes longer than 600 seconds to
complete, it is cancelled and the LEDs go out. In this case,
repeat the steps listed previously under 5.1 Bluetooth
pairing.
5.2. Automatic Bluetooth
pairing)
Note
• Make sure that your Bluetooth
on and Bluetooth
• Make sure that your Bluetooth
visible for other Bluetooth
• For more information, please refer to the operating
instructions of your terminal device.
• Switch the headset on using the MFB button (6). The blue LED
begins to flash and the headset automatically connects with the
last terminal device used.
Note
• If the connection was successful, the LED (5) flashes and a
voice says 'Your device is connected'.
• If the connection attempt takes longer than 600 seconds to
complete, it is cancelled and the LEDs go out. In this case,
repeat the steps listed previously under 5.1.
• It may be necessary to make settings on your terminal device
to enable automatic connection with the paired headset.
®
password
®
device.
®
connection (after successful
®
-capable terminal device is
®
is activated.
®
-capable terminal device is
®
devices.
®
®
3