Product Description And Specifications; Technical Data; Product Features; Initial Operation - Bosch 0 275 007 900 Originalbetriebsanleitung

OBJ_BUCH-1395-001.book Page 10 Monday, January 17, 2011 2:56 PM
10 | English
Product Description and
Specifications

Technical Data

Battery Charger
Article number
Rated voltage
Frequency
Battery charging
voltage
Charging current
– Rapid-charging
operation
– Silent-charging
operation
Allowable charging
temperature range
Charge duration (for
8 Ah battery capacity)
approx.
– Rapid-charging
operation
– Silent-charging
operation
Number of battery
cells
Weight according to
EPTA-Procedure
01/2003
Protection class
The values given are valid for a nominal voltage [U] of
230 V. For different voltages and models for specific
countries, these values can vary.

Product Features

The numbering of the product features refers to
the illustration of the battery charger on the
graphics page.
1 Ventilation openings
2 Charger socket
3 Mains voltage selector switch
4 Charger plug
0 275 007 900 | (17.1.11)
5 Safety warnings, charger
6 Button for charge operation
7 Operation indicator
8 Battery charger
9 Charge connector
Charger
10 Socket for charge connector
11 Standard battery
0 275 007 900
12 Rear rack battery
V 115/230
13 Battery charge control indicator
Hz 50/60
V= 36
Operation
A 4
A 1

Initial Operation

°C 0...+40
Connecting the Charger (see figures A–B)
Set the voltage of your power source on the
mains voltage selector switch 3 of the charger.
You can select between 115 V and 230 V.
h 2.5
h 8
10–80
Then, insert the charger plug 4 of the power
cord into the charger socket 2 of the charger.
kg 0.8
Connect the mains cable to the mains supply.
/I
The operation indicator 7 on the charger lights
up.
Switch the battery off and remove it from the
holder of the eBike. For this, read and observe
the operating instructions of the battery.
Insert the charge connector 9 of the battery
charger into the socket 10 on the battery. The
operation indicator 7 on the charger flashes.
Place the battery only on clean surfaces. In
particular, avoid contaminating the charge
socket and the contacts, e.g. by means of
sand or ground.
Observe the mains voltage! The voltage of
the power supply must correspond with the
data given on the nameplate of the battery
charger. Battery chargers marked with 230 V
can also be operated with 220 V.
Do not connect the charger to the mains
supply until after the correct mains voltage
has been set on the mains voltage selector
switch 3. Otherwise, the charger can be-
come damaged.
Bosch ebike Systems