Service Information; Top Cover Replacement; Foot Box Power Board Replacement; Foot Box Transformer Replacement - Stryker XPRT Bedienungs- Und Wartungshandbuch

English

TOP COVER REPLACEMENT

1 . Unplug the support surface power cord from the power source .
2 . Unzip the support surface cover at the patient's right side midsection and remove .
3 . Line up the new cover zipper with the bottom cover zipper and zip them together .
4 . Plug the support surface power cord into the power source and test the functionality before returning to service .

FOOT BOX POWER BOARD REPLACEMENT

Required Tools:
• Phillips Screwdriver
• ESD System (Static Strap)
1 . Unplug the support surface power cord from the power source .
2 . Fold the foot section of the support surface back over the head section .
3 . Using a Phillips screwdriver, remove the seven Phillips head screws holding the cover to the foot box assembly
and remove the cover .
4 . Properly ground yourself .
5 . Unplug the cable connections from the power board . Note the locations so the new power board will be connected
properly .
6 . Using a Phillips screwdriver, remove the six screws holding the power board to the foot box assembly .
7 . Remove the power board and contact your local Stryker service representative to return for fault evaluation .
8 . Reverse the procedure to install the new power board .
9 . Plug the support surface power cord into the power source and test the functionality before returning to service .

FOOT BOX TRANSFORMER REPLACEMENT

Required Tools:
• Phillips Screwdriver
• ESD System (Static Strap)
• Small Regular Screwdriver
1 . Unplug the support surface power cord from the power source .
2 . Fold the foot section of the support surface back over the head section .
3 . Using a Phillips screwdriver, remove the seven Phillips head screws holding the cover to the foot box assembly
and remove the cover .
4 . Properly ground yourself .
5 . Using a small regular screwdriver, unplug the cable connections from the junction block . Note the locations so the
new transformer will be connected properly .
6 . Using a Phillips screwdriver, remove the screw from the bottom of the foot box securing the transformer to the foot
box assembly .
7 . Remove the transformer and contact your local Stryker service representative to return for fault evaluation .
8 . Reverse the procedure to install the new transformer .
9 . Plug the support surface power cord into the power source and test the functionality before returning to service .
Return To Table of Contents
1-44

Service Information

2950-109-005 REV B www.stryker.com