Herunterladen Inhalt Inhalt Diese Seite drucken

Hama SOUNDCHEST Bedienungsanleitung Seite 6

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 8
4.5 Automatic Bluetooth
successful pairing)
• Make sure that your Bluetooth
device is on and Bluetooth
• Make sure that the speaker is located within the
Bluetooth
range of max. 10 metres.
®
• Switch on the speakers as described in 4.1
Switching the product on and off.
• After successful connection, the status LED (4) will
light up in blue. An acoustic signal confirms that
connection was successful.
Note – Connection impaired
• After the speaker and terminal device have been
paired, a connection is established automatically.
If the Bluetooth
connection is not established
®
automatically, check the following:
• Check the Bluetooth
device to see whether Hama Soundchest is
connected. If not, repeat the steps listed under
Bluetooth
pairing.
®
• Check whether your terminal device and the
speaker are less than 10 metres apart. If not, move
them closer together.
• Check whether obstacles are impairing the range.
If so, move the devices closer together.
• Check whether the audio cable is connected to the
speaker. If so, disconnect it.
4.6 Audio playback (via Bluetooth
Start and control audio playback on the connected
terminal device accordingly. Alternatively, audio
playback can also be controlled on the speaker (if the
connected device supports this function).
• Press the
function button (1) to start or pause
audio playback.
• Swipe from left to right or right to left on the
touchpad to go to the next or previous track.
• Turn the rotary control to the left or right to increase
or decrease the volume.
4
connection (after
®
capable terminal
®
is activated.
®
settings of your terminal
®
)
®
4.7 Hands-free function
You can use the speaker as a hands-free set for your
mobile phone. For this function, the mobile phone must
be connected to the speaker via Bluetooth
• Press the function button
incoming call.
• Press and hold the function button
2 seconds to reject an incoming call.
• You can put a call on hold by pressing and holding
the function button
• Press and hold the function button
continue the call.
• During a call, press the function button
end the call.
• Press and hold the function button
2 seconds to call the most recently dialled number.
Note – Call quality
To increase the call quality, make sure that you are
near the speaker with your mobile phone during the
call.
4.8 Equaliser
The equaliser (7) enables optimum adjustment of
the sound to suit the requirements both indoors and
outdoors. Pressing the button will change the sound
mode; the active mode (Indoor/Outdoor) is displayed on
the sound mode status LED (5).
5. Care and Maintenance
• Only clean this product with a slightly damp, lint-free
cloth and do not use aggressive cleaning agents.
6. Warranty Disclaimer
Hama GmbH & Co KG assumes no liability and provides
no warranty for damage resulting from improper
installation/mounting, improper use of the product or
from failure to observe the operating instructions and/
or safety notes.
7. Service and Support
Please contact Hama Product Consulting if you have
any questions about this product.
Hotline: +49 9091 502-115 (German/English)
Further support information can be found here:
www.hama.com
.
®
(1) once to answer an
(1) for approx.
(1) for approx. 2 seconds.
(1) again to
(1) once to
(1) for approx.

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis