Installation; Connecting The Blowing And Vacuum ■ Tube (02) - AL-KO LBV 4090 Betriebsanleitung

GB
ment – for damage. Only use
the charging unit when it is in
proper working order.
■
Do not use the charging unit
in environments where there
is a potential risk of explosion
and/or fire.
■
Only operate the charging unit
indoors and do not expose it
to moisture and humidity.
■
Always place the charging
unit on a well ventilated and
non-inflammable surface be-
cause it heats up during the
charging process. Keep the
ventilation slots clear and do
not cover the charging unit.
■
Before connecting the
charging unit, make sure that
the mains voltage matches
the voltage stated in the
"Technical data".
■
Only use the mains cable for
connecting the charging unit,
not for any other purpose. Do
not carry the charging unit by
the mains cable and do not
remove the power plug from
the power outlet by pulling on
the mains cable.
■
Protect the mains cable from
heat, oil and sharp edges to
prevent it being damaged.
■
Do not use the charging unit
and rechargeable battery
38
when soiled or wet. Before us-
ing the charging unit, clean
and dry the rechargeable bat-
tery.
■
Do not open the charging unit
or rechargeable battery.
There is a danger of electric
shock and short-circuit.
■
For your own safety, only
have the charging unit re-
paired by qualified specialist
personnel using genuine
spare parts.
■
Dry the unused charging unit
and store in a closed place.
Unauthorised persons and
children must not have access
to the charging unit.

4 INSTALLATION

WARNING!
Danger if assembly is not carried out
completely!
Operation of an incompletely assembled
appliance can result in serious injury.
■
Only operate the appliance when it
is fully assembled.
■
Do not insert the battery into the ap-
pliance until it is fully assembled.
■
Check that all safety and protective
devices are in place and functioning
correctly before switching on.
4.1 Connecting the blowing and vacuum
tube (02)
The blowing and vacuum tube must first be com-
bined. The flat nozzle (02/1) of the blow tube and
the intake opening (02/2) of the vacuum tube
must point in the same direction.
1. Attach the blow tube to the vacuum tube as
follows:
■
The metallic guide plate (02/3) of the
blow tube and the guide (02/4) of the
Installation