Hc Warning; For Models With Water Dispenser - Beko RDSE465K31W Bedienungsanleitung

Safety and environmental instructions
contact the electrified areas and
cause short circuit or electric shock!
Do not wash the product by spraying
•
or pouring water on it! Danger of
electric shock!
In case of malfunction, do not use
•
the product, as it may cause electric
shock. Contact the authorised
service before doing anything.
Plug the product into an earthed
•
socket. Earthing must be done by a
qualified electrician.
If the product has LED type lighting,
•
contact the authorised service for
replacing or in case of any problem.
Do not touch frozen food with wet
•
hands! It may adhere to your hands!
Do not place liquids in bottles and
•
cans into the freezer compartment.
They may explode.
Place liquids in upright position after
•
tightly closing the lid.
Do not spray flammable substances
•
near the product, as it may burn or
explode.
Do not keep flammable materials
•
and products with flammable gas
(sprays, etc.) in the refrigerator.
Do not place containers holding
•
liquids on top of the product.
Splashing water on an electrified part
may cause electric shock and risk of
fire.
Exposing the product to rain,
•
snow, sunlight and wind will cause
electrical danger. When relocating
the product, do not pull by holding
the door handle. The handle may
come off.
Take care to avoid trapping any part
•
of your hands or body in any of the
moving parts inside the product.
Do not step or lean on the door,
•
drawers and similar parts of the
refrigerator. This will cause the
product to fall down and cause
damage to the parts.
Take care not to trap the power
•
cable.

1.1.1 HC warning

If the product comprises a cooling
system using R600a gas, take care to
avoid damaging the cooling system and
its pipe while using and moving the
product. This gas is flammable. If the
cooling system is damaged, keep the
product away from sources of fire and
ventilate the room immediately.
C
The label on the inner left side
indicates the type of gas used in
the product.
1.1.2 For models with
water dispenser
Pressure for cold water inlet shall
•
be maximum 90 psi (620 kPa). If
your water pressure exceeds 80 psi
(550 kPa), use a pressure limiting
valve in your mains system. If you
do not know how to check your
water pressure, ask for the help of a
professional plumber.
If there is risk of water hammer
•
effect in your installation, always
use a water hammer prevention
4 /19 EN
Refrigerator / User Manual