Injectors Replacement - Electrolux EKK6450AO Benutzerinformation

13.3 Flexible nonmetal pipes
connection
If it is possible to easily control the con-
nection in its full area, you can use a flexi-
ble pipe. The flexible pipe must be tightly
attached by clamps.
Installation: use the pipe holder. Always
engage the gasket. Then continue with
the gas connection. The flexible pipe is
prepared for apply when:
– it can not get hot more than room tem-
perature, higher than 30°C;
– it is no longer than 1500 mm;
– it shows no throttles;
– it is not subject to traction or torsion;
– it does not get in touch with cutting
edges or corners;
– it can be easily examined in order to
check its condition.
The control of preservation of the flexible
pipe consists in checking that:
– it does not show cracks, cuts, marks of
burnings on the two ends and on its full
length;
– the material is not hardened, but shows
its correct elasticity;
– the fastening clamps are not rusted;
– expired term is not due.
If one or more defects are visible, do not
repair the pipe, but replace it.
When installation is complete,
make sure that the seal of each
pipe fitting is correct. Use a soapy
solution, not a flame!
The gas supply ramp is on the rear side of
the control panel.
WARNING!
Before gas connection discon-
nect the mains plug from the
mains socket or switch off the
fuse in the fuse box. Close the
primary valve of the gas sup-
ply.
A B
A)
Gas connection point (only one point
is applicable for appliance)
B) Gasket
C) Adjustable connection
D) Natural Gas pipe holder
E) LPG pipe holder
The appliance is set to default
gas, to change the setting choose
pipe holder from the list. Always
use the gasket sealing
13.4 Adjustment to different
types of gas
WARNING!
Let only an authorized person do
the adjustment to different types
of gas.
This appliance is for operation
with natural gas.
With the correct injectors, you can
also operate it with liquid gas.
WARNING!
Before replacing the injectors,
make sure that the gas knobs are
in the Off position and disconnect
the appliance from the electrical
supply. Let the appliance cool off
fully. There is a risk of injury.

13.5 Injectors replacement

1. Remove the pan supports.
2. Remove the caps and crowns of the
burner.
3.
With a socket spanner 7 remove the
injectors and replace them with the
ones which are necessary for the type
of gas you use.
ENGLISH 29
C
E D