Silk'n Infinity Bedienungsanleitung Seite 42

9. Place the TREATMENT SURFACE on the skin, making sure the skin is spread evenly and
smoothly. As soon as the TREATMENT SURFACE is in full contact with the skin, the
READY/SKIN TONE WARNING INDICATOR LIGHT will start blinking slowly.
Make sure to touch the TOUCH ELECTRODE on the underside of the device to ensure the
galvanic system can complete the circuit and activate.
10. Press the PULSE TRIGGER. The device will first determine the colour of your skin. If the
colour of the skin is light enough for safe application, the device will activate the galvanic
circulation. You might feel a slight tingling sensation. This is completely normal: the galvanic
treatment is now working to enlarge your pores for a better application of the treatment.
Directly afterwards the device will flash a pulse of light onto your skin, and the READY/SKIN
TONE WARNING INDICATOR LIGHT will turn off. You will see a bright flash of light and
simultaneously hear a subtle pop sound, which is a normal noise for the device. You will feel
a mild sensation of warmth and tingling. Silk'n Infinity™ will immediately recharge for the
next pulse.
After a few seconds the READY/SKIN TONE WARNING INDICATOR LIGHT will turn on
again and start blinking slowly when pressed again to the skin.
11. Remove the TREATMENT SURFACE from the treated area of skin.
12. Choose a method of application for your treatment session. Silk'n Infinity™ can be applied
in two ways: "Pulsing" and "Gliding" (for more details see applicatoin methods frame below).
A. For the PULSING method, follow steps 9 to 11 on another spot repeatedly until the
entire area is fully covered.
B. For the GLIDING method, hold the PULSE TRIGGER down continuously and slide the
device smoothly along the treated area.
If your skin blisters or burns, STOP USE IMMEDIATELY!
40