Charging Mobile Devices With The Power Bank - Silvercrest SQWP8000 1A1 Bedienungs- Und Sicherheitshinweise

Charging mobile devices with the power
bank
You can charge up to three devices at the same time using the
power bank
8
the output current must not exceed 3 A.
Connect the USB cable
the device to be charged to the USB output
Micro-USB port of the USB Cable
of device to be charged. The charging process will start
automatically.
If your mobile device has a USB type C input, you can use a
type C to type C connection cable (not included) to connect
your device's type C input to this power bank's USB Type C
output 3 . The charging process will start automatically.
At the same time, you can place the device to be charged on the
Qi charging surface
In case if the charging process does not begin immediately,
press the ON / OFF button
process. The current battery status of the power bank
displayed during the charging process by the battery status
indicator
6
To end the charging process, disconnect the USB charging cable
from the mobile device and the power bank
bank will switch OFF and battery status indicator
off after approx. 30 seconds.
Or simply double click the ON / OFF button
bank will switch off.
8
NOTE:
If you use both USB ports, a voltage of 5 V will be output at both
outputs. The maximum output current must not exceed 3 A for both
outputs.
GB 16
. If all outputs are used at the same time, the sum of
9
.
7
.
or the original charging cable of
to the Micro-USB input
9
5 briefly to begin the charging
. Then connect
2
8 is
. The power
8
6 will switch
. The power
5