Silvercrest SQWP8000 1A1 Bedienungs- Und Sicherheitshinweise Seite 13

Do not charge when the Qi wireless charger is covered with a
towel, layer of dust, etc.
Do not allow the Qi charging surface to get wet from water,
beverages, etc.
Do not use the Qi charging surface if it is malfunctioning.
Immediately switch the product off and remove the charging
cable from the product if you smell burning or see smoke. Have
the product examined by a qualified technician before using it
again.
Do not subject the Qi charging surface with a strong forces or
impact. Failure to do so may result in damage, injury and/or
malfunction.
Do not place magnetic recording media inside the charging
area during charging. The magnetism generated may erase the
data on credit cards. It may also cause wristwatches and other
precision instruments to malfunction.
During charging and immediately after charging, the Qi
charging surface and mobile device will be warm. This is normal
and not a malfunction. If there is an unusual heating, check the
Qi charging surface and mobile device.
Always place only one mobile device to charge on the Qi
charging surface. Only one device can be charged at a time.
Compatibility with all Qi devices cannot be guaranteed.
Do not attach an anti-slip mat or stickers to the Qi charging
surface. The presence of an anti-slip mat or stickers between the
mobile device to be charged and the Qi charging surface that
may prevent charging start.
If a cover or decorative accessory that does not comply with
the Qi wireless power standard has been attached to the
supported device, it may not be possible for the device to be
charged depending on the material, thickness, etc. of the cover
or accessory. In such cases, remove the attached cover or
accessory.
If charging does not start even after the supported device has
been placed in the charging area, place the device near the
[Qi] mark in the center of the charging area.
Before starting with wireless charging, read the instructions
provided with the mobile device as well.
GB 13