Symbols On The Product - Husqvarna CG 200 Bedienungsanweisung

1. Safety lever (operator presence control)
2. Steering shaft
3. Shaft adjustment knob
4. Depth adjustment knob (mm)
5. Quick raise/lower lever
6. Lifting eye
7. Engine / Motor
8. Belt tensioner
9. Chassis
10. Transmission
11. Belt guard
12. On / off switch
13. Drum guard plate
14. Drum guard fasteners
15. 200 mm wide drum
16. Drain extension
17. Dust extractor hose
18. Type plate

Symbols on the product

WARNING! The product can be a
dangerous tool if used incorrectly or
carelessly, which can cause serious or fatal
injury to the operator or others.
Please read the instructions for use prior to
operating the product for the first time.
This symbol indicates that the product is in
conformance with the applicable European
directive.
Wear personal protective equipment. See
Personal protective equipment on page 7
for instructions.
Noise emission to the environment
according to the European Community's
Directive. The product's emission is
specified in the Technical data chapter and
on the label.
Hot surface.
4
WARNING! Dust forms when cutting, this
can cause injuries if inhaled. Use an
approved breathing mask. Avoid inhaling
exhaust fumes. Always provide for good
ventilation.
Caution, risk of cutting.
Low speed.
High speed.
Choke control.
Environmental marking. Symbols on the
product or its packaging indicate that this
product cannot be handled as domestic
waste. It must instead be submitted to an
appropriate recycling station for the recovery
of electrical and electronic equipment. By
ensuring that this product is taken care of
correctly, you can help to counteract the
potential negative impact on the
environment and people that can otherwise
result through the incorrect waste
management of this product. For more
detailed information about recycling this
product, contact your municipality, your
domestic waste service or the shop from
where you purchased the product.
Other symbols/decals on the product refer to special
certification requirements for certain markets.
130 - 003 - 18.08.2017