Inhaltsverzeichnis
Werbung
BOBBIN SETTING
A. REMOVING THE BOBBIN
1. Pull the bobbin cover latch to the right and
remove the bobbin cover.
2. Lift up the bobbin from the machine.
B. SETTING SPOOL OF THREAD ON
SPOOL PIN
1. Pull up the left end of spool pin.
2. Set the spool of thread on spool pin so that
the thread unrolls from the front of the spool.
3. Set the spool cap on spool pin as far as it
will go.
a: Reverse spool cap direction according to
the size of spool.
C. WINDING THE BOBBIN
1. Hold thread in both hands and hook thread
to the guide from rear opening.
2. Bring thread frontward and pass through the
thread guide plate from rigth to left.
3. Bring thread to the right and pass thread to
the thread guide from under side. Pass
through under tension disc in counter-
clockwise.
4. Insert thread through hole in bobbin and
place the bobbin on bobbin winder spindle.
Push bobbin to the right to engage bobbin
winder. L.C.D. will indicate the bobbin
winding mode.
5. Hold the end of the thread and start the
machine by pressing the start/stop button or
pressing the foot controller pedal.
6. After the bobbin winds a few turns, stop the
machine by pressitng the start/stop button
or releasing the foot controller pedal. Cut
the thread near hole.
7. Start the machine again.
8. The bobbin winding will stop automatically
when bobbin is full. (Release the pedal.)
9. Push the bobbin and spindle to the left.
10 Remove the bobbin from the spindle and cut
the thread.
20
20
Werbung
Inhaltsverzeichnis
